Spectra-precision Survey Pro 3.80 Recon GPS Reference Manual Uživatelský manuál stáhnout pdf (Strana 15)

Job Menu

: establishes communication with the radio

firmware and opens the Radio Settings screen (Page R-15), where you

can change the radio channel and sensitivity settings.

Radio Communications Screen

-or-

The Radio Communications screen is used to change the settings for

communication between the base or rover receiver and the radio.

GPS Receiver Port

: is where you select the serial port

the receiver will use to communicate with the radio.

Baudrate

: is where you select the baud rate the receiver

will use to communicate with the radio.

Parity

: When selectable, is where you select the parity

the receiver will use to communicate with the radio.

: automatically sets all the selectable values to

their defaults based on the selected hardware.

: sets the selected radio communication

settings in the receiver.

Note: The radio communication settings are also set in

the receiver during the base and rover setup procedure.

Therefore, you will not usually have to use the Receiver Set button on

this page.

Radio Settings Screen

-or-

The Radio Settings screen is used to configure settings of the base or

rover radio mode. All settings available are described below.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 98 99

Žádné komentáře

Spectra-precision Survey Pro 3.80 Recon GPS Reference Manual Uživatelský manuál Strana 15